Threading The Upper Thread - Husqvarna Viking Platinum 995E User Manual

Auxiliary Spool Pin
The auxiliary spool pin is used when wind-
ing a bobbin from a second spool of thread
or for a second spool when sewing with a
twin needle.
When using the auxiliary spool pin, place
the large spool holder and a felt pad under
the thread spool.

Threading the Upper Thread

When threading the upper thread, make
sure that the presser foot is raised and the
needle is in the up position.
Switch off the main switch.
1. Pull the spool pin out. Place the spool
on the spool pin with spool holder
(follow the instuctions on previous
page). The thread should reel clockwise.
Push the spool pin back in.
Hold the thread near the spool using
your right hand. Use your left hand to
bring the end of the thread in the direc-
tion of the arrows on the machine.
2. Bring the thread into the pre-tension
thread guide (a). Bring the thread down
a
b
and up between the thread tension discs
(b).
3. Continue threading in the direction indi-
cated by the arrows. Bring the thread
from the right when threading into the
slot on the take-up lever.
4. Pull the thread into the last guide just
above the needle.
5. The needle is threaded from front to
back (see needle threader for further
instructions).
6. Place the thread under the presser foot
and into the thread cutter on the left side
of the machine, pull it downwards to cut
it.
Learn your Platinum
7