Selection Buttons; Stitch Selection Menus - Husqvarna Viking Platinum 995E User Manual

Functions and InfoDisplay on your Platinum 775
FUNC
Touch this button to step between the dif-
ferent modes of your Platinum 775. There
are three different modes, norm,
and . The
REP NORM
mode) is always active when the machine
is turned on. Touch once to activate the
program mode (used when programming),
then touch again to enter the
is used to sew a programmed combination.
Touch again to return to
active mode is indicated on the display.

Selection Buttons

These buttons are used to advance or
return within a programmed sequence,
when adjusting the twin needle width, the
buttonhole size or the buttonhole balance.
Memory
Your Platinum 775 has four different
memories where programmed combinations
can be saved. Each memory will hold up to
55 stitches or letters. The button is used to
advance to the memory required in
. The current memory number is shown
REP
in the lower right corner of the display.
20
PROG
mode (normal sewing
mode that
REP
mode. The
NORM
PROG
CLR
Touch this button in
whole or a part of a program (see page 31).
When a program in a memory has been
deleted, the stitch length and -width are
shown as 0.0 on the display.
CLR – Language
This button is also used to set the
used by your Platinum 775. All
GUAGE
machines are pre set to English. To change
the language, touch
the machine. Then step between the lan-
gages by pressing the selection buttons.
Touch to con rm your langauge selec-
M
tion.

Stitch Selection Menus

Your Platinum 775 has three different main
menus:
Stitches
Alphabets
Alphabet sub menu
or
An icon in the upper right corner of the
display shows the currently selected menu.
Read more about how to select the differ-
ent stitches on the following pages.
to delete the
PROG
-
LAN
while turning on
CLR