Additional Information; Installing The Rear Port Cover; Removing The Rear Port Cover - HP Compaq Pro 6300 Hardware Reference Manual

Additional Information

For more information on removing and replacing hardware components, the Computer Setup utility,
and troubleshooting, refer to the Maintenance and Service Guide (available in English only) for your
computer model at http://www.hp.com.

Installing the Rear Port Cover

1. Ensure that all cables are connected.
2.
Place the cover against the computer (1), lining up the cable lock slot in the cover about 12 mm
(0.5 inch) below the cable lock slot in the computer. Slide the cover up and into position (2).
Figure 2-1

Removing the Rear Port Cover

1. If a cable lock is installed on the rear of the unit, remove the lock.
Installing the Rear Port Cover
Additional Information
9