Section 1: Listing And Code Approvals; Appliance Certifications; Mobile Home Approved; Glass Specifications - Quadra-Fire 41I-ACC Owner's Manual

Wood insert automatic combustion control
Hide thumbs Also See for 41I-ACC:
Table of Contents

Advertisement

41I ACC Wood Insert
1
Listing and Code Approvals
A. Appliance Certification
Model:
41-I (ACC) Insert
Laboratory:
Intertek
Report No:
100428837PRT-001
Type:
Solid Fuel Type, Listed Room Heater
Standard:
UL1482 and ULC S628-93 and
(UM) 84-HUD, Mobile Home
Approved.
NOTE: This installation must conform with local codes. In the
absence of local codes you must comply with the UL1482, (UM)
84-HUD and NPFA211 in the U.S.A. and the ULC S628-93 and
CAN/CSA-B365 Installation Codes in Canada.
The Quadra-Fire 41I Wood Insert (ACC) meets the U.S.
Environmental Protection Agency's 1990 particulate emis-
sion standards.
B. Mobile Home Approved
• This appliance is approved for mobile home installa-
tions when not installed in a sleeping room and when
an outside combustion air inlet is provided.
• The structural integrity of the mobile home floor, ceil-
ing, and walls must be maintained.
• The appliance must be properly grounded to the frame
of the mobile home with #8 copper ground wire, and
chimney must be listed to UL103 HT or a listed UL-
1777 full length six inch (152mm) diameter liner must
be used.
• Outside Air Kit, part OAK-ACC must be installed in a
mobile home installation.
C. Glass Specifications
This stove is equipped with 5mm ceramic glass. Replace
glass only with 5mm ceramic glass. Please contact your
dealer for replacement glass.
Page 6
D. BTU & Efficiency Specifications
EPA Certified:
Efficiency:
BTU Output:
Heating Capacity:
Vent Size:
Firebox Size:
Max Wood Length:
Fuel:
Shipping Weight:
Fire Risk.
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be
voided by, the following actions:
• Installation and use of any damaged appliance.
• Modification of the appliance.
• Installation other than as instructed by Hearth & Home
Technologies.
• Installation and/or use of any component part not approved
by Hearth & Home Technologies.
• Operating appliance without fully assembling all components.
• Operating appliance without legs attached (if supplied with
unit).
• Do NOT Overfire - If appliance or chimney connector glows,
you are overfiring.
Any such action that may cause a fire hazard.
Improper installation, adjustment, alteration, service or
maintenance can cause injury or property damage.
For assistance or additional information, consult a qualified
installer, service agency or your dealer.
NOTE: Hearth & Home Technologies, manufacturer of
this appliance, reserves the right to alter its products,
their specifications and/or price without notice.
Quadra-Fire is a registered trademark of Hearth & Home
Technologies.
7045-178
4.3 grams per hour
up to 80.2%
11,700 to 25,900
up to 1800 sq ft depending
on climate zone
6 inches
2.45 cubic feet
18 inches
Cord Wood
345 lbs
WARNING
September 15, 2011
R

Advertisement

Table of Contents
loading

Table of Contents