Zero-Clearance Adjustable Trim Support - Quadra-Fire 41I-ACC Owner's Manual

41I ACC Wood Insert
H. Zero Clearance Adjustable Trim Support,
2" to 10"
Part No. 841-0990, size 9" x 45" and
Part No. ADJSPT-12, size 12" x 50"
Included in Kit: (
1) Trim Top, (1) Trim Front, (2) Trim
Sides, Double-Sided Tape (already installed)
Tools Needed:
Phillips Head Screwdriver, Sheet Metal
Shears, Measuring Tape, Gloves
1. The 10 screws on each set of scissors will already be
loose when shipped. Figure 44.1.
2. Expand scissors to desired height. Tighten screws
to hold in place using Phillips Head screwdriver. See
Figure 44.2.
3. Measure front and side trims to required height to cover
scissors and mark pieces for cutting. Cut excess mate-
rial from top of trim's edge, not bottom. This edge will
be sharp; wear gloves to prevent injury to your hands.
Figure 44.2.
4. Using sheet metal shears, cut trim along the marked
edge. The cut edge fits under lip of top trim, so it allows
for some variance in your straight edge.
5. The double-sided tape that holds front and side trims
to scissors has a particularly powerful bonding adhe-
sive. Adjustments are extremely difficult once trim has
adhered to tape. Do a dry run first without removing
paper from tape.
6. Place cut edge of trim under top lip and into position on
scissors. Place side pieces on first and then front piece.
The front piece overlaps side pieces. NOTE: The trim
in the Flush Mount Kit is one piece.
7. Once you are satisfied with the positioning, remove trim
and set aside.
8. Remove the paper from double-sided tape that is to
accept trim side. Align side and then press hard against
tape to secure side piece. Repeat for other side. Install
front trim piece last.
9. There are 3 holes in the back flange of the top to secure
it to the wall if necessary. Use the appropriate fastener
for the type of wall material, i.e., brick, sheetrock, etc.
NOTE: 3/8" ( 9.5mm) thick tile or like material can be cut
to size and fit under lip of top trim edge for a decorative
touch. Figure 44.3.
10. T hermal protection of 1-1/2 inches (38mm), "k" value of 0.49
and R value of 3.06 under the zero-clearance trim support.
Figure 44.4.
Page 44
EXPLODED VIEW OF SCISSORS
DOUBLE-SIDED TAPE
Figure 44.1
EXPAND SCISSORS TO DESIRED HEIGHT
INS T AL L FRONT TRIM LAS T .
CORNERS OVERLA P SIDE
TRIM PIECES
Figure 44.2
Figure 44.3
Figure 44.4
7045-178
SCREWS ARE CIRCLED
DOUBLE-SIDED TAPE
CUT T O P EDGE OF TRIM,
NOT BOT T OM EDG E
Decorative tile may
be installed
Thermal
Protection
September 15, 2011
R