Baffle Removal; Door Handle Assembly - Quadra-Fire 41I-ACC Owner's Manual

41I ACC Wood Insert
D. Baffle Removal
1. Remove all ash from the firebox, and extinguish all hot
embers before disposal into a metal container.
2. The baffle board has 2 pieces. With the ceramic blanket
still in place, slide one baffle piece over the top of other one
but still keep it all components inside the firebox. Figure
24.1.
3. It is easier to remove both baffle boards and ceramic
blanket after the tube channel assembly has been partially
disassembled. Follow steps 1 through 4 on page 25 for
removal of the tube channel assembly. It is not necessary
to completely remove the tube channel assembly.
4. Re-install in reverse order. Be sure the baffle boards and
ceramic blanket are in their proper positions. Figure 24.2.
The ceramic blanket and both baffle boards
and tube channel assembly can all be
removed at the same time.
Figure 24.1
Ceramic Blanket
Baffle
Figure 24.2
Page 24
Baffle
7045-178
E. Door Handle Assembly
CAUTION! Do not overtighten lock nut. The door handle
needs to move smoothly.
Hook Door Latch
Washer
Nut 1/4-20
Washer, 5/8 x 1/4
Door Latch Bracket
Door Latch Adjustment
It is important the door gasket has a proper seal. As the
gasket compresses or "seats" during use, it may become
necessary to adjust or tighten the door latch.
1. Open door to access adjustment bolt.
2. Using a 5/32 allen tool, turn the adjustment bolt clock-
wise slightly.
3. Close door to test adjustment. If more is needed, repeat
the previous process.
Door Handle
Fiber Handle
Adjustment
Bolt
September 15, 2011
R