Baffle & Ceramic Blanket Removal - Quadra-Fire 27I-ACC Owner's Manual

27I-ACC
E. Baffle & Ceramic Blanket Removal
1. Remove all ash from the firebox, and extinguish all hot
embers before disposal into a metal container.
2. It is easier to remove both baffle boards and ceramic
blanket after the tube channel assembly has been partially
disassembled and the right side lowered. Follow steps
1 through 4 on page 25 for removal of the tube channel
assembly. It is not necessary to completely remove the
tube channel assembly.
3. Once the baffle protection cover has been removed, pull
the baffle boards and ceramic blanket forward about 1
inch (25mm) and then overlap the baffles about 1-2 inches
(25-51mm). Figure 24.1.
4. Slide the tube channel assembly to the left as far as it will
go and lower the right side. Remove the baffle boards
and ceramic blanket together. Figure 24.2.
5. Re-install in reverse order. Be sure the baffle boards and
ceramic blanket are in their proper positions. See Figure
13 .1 on page 13.
The ceramic blanket and both baffle boards
and tube channel assembly can all be
removed at the same time.
Figure 24.1
Ceramic Blanket
Baffle
Figure 24.2
24
Baffle
7046-191 October 22, 2013