Table of Contents
Advertisement
C. Snap Disc Replacement
Service Part: SRV230-0470
1. Locate the snap disc bracket assembly at the bottom left
rear corner of the appliance.
2. A magnet holds the bracket to the appliance. Pull the
bracket down away from the appliance to expose the
snap disc.
3. Pull the snap disc and spade connectors up and out of
bracket as shown in Figure 22.1
4. Using a Phillips head screw driver, remove the 2 screws
from the snap disc and then remove the snap disc from
the spade connectors. Replace with new snap disc and
re-connect to spade connectors.
5. Push the snap disc and spade connectors back inside
bracket and re-attach the bracket to the appliance.
Snap Disc
Magnet
Figure 22.1
D. Baffle Removal
Service Part: SRV7038-118
1. Remove all ash from the firebox, and extinguish all hot
embers before disposal into a metal container.
2. The baffle board has 2 pieces. With the ceramic blanket
still in place, slide one baffle piece over the top of other
one and pull out top piece through the door opening and
then remove bottom baffle piece (Figure 22.2).
3. Remove the ceramic blanket (Figure 22.3).
4. Re-install the baffle pieces one piece at a time. Be sure
the baffle boards are even with the front manifold tube
and is resting on all tubes (Figure 22.2, Figure 22.4,
and Figure 22.5).
5. To re-install the ceramic blanket, it is easier to fold it
in half first. Place on top of baffle board, open up and
flatten and smooth out the blanket. Re-check the baffle
board for correct positioning (Figure 22.4).
22
Figure 22.2 - Baffle
Spade
Figure 22.3 - Ceramic Blanket
Connectors
Figure 22.4
Figure 22.5
7038-227L
Baffle Board even with front tube & resting
on all tubes
Ceramic Blanket on Top
Tube Channels
2 pc Baffle Board
Burn Rate
Air Control
Start-Up Air
Control
08/23
Advertisement
Table of Contents
