Squaring Crosscut Fence To Blade - Grizzly G0460 Owner's Manual

Squaring Crosscut
Fence to Blade
Squaring the crosscut fence to the blade ensures
that cuts made with the crosscut fence will be
square. This procedure consists of cutting a piece
of scrap plywood five times, then adjusting the
fence as necessary.
To square the crosscut fence with the blade:
1.
Make sure the blade is parallel with the slid-
ing table.
2. Prepare the scrap test piece by numbering all
four sides as shown in Figure 80.
Figure 80. Fence adjustment test piece.
G0460/G0461 12" Sliding Table Saw
3.
Use the crosscut fence to cut
side of the test piece, then cut side 1 again
(make 5 cuts total).
4. Measure the test piece diagonally from cor-
ner-to-corner as shown in Figure 80.
— If both measurements are not within
then the crosscut fence needs to be adjust-
ed. Proceed to Step 5.
— If both measurements are within
you are finished with this procedure.
5. Loosen the hex nut shown in Figure 81 and
rotate the hex bolt to square the crosscut
fence.
Hex Nut
Figure 81. Crosscut fence adjustment cam.
6. Tighten the hex nut and repeat Steps 3-6.
⁄ " off of each
1
2
⁄ ",
1
16
⁄ " then
1
16
-47-