Table of Contents
Advertisement
SAVE MODE
Once you have some sounds in memory that you have edited, you will no doubt want to save
them for future retrieval. Pressing SAVE gives this screen:
SELECTING FLOPPY OR HARD DISK
If the cursor is not already on the field, move the cursor to the
select
NOTE: HARD-:A" will appear only when the hard disk is connected. CD-ROM:A allows you to
select "CDROM:A", but you cannot save.
SELECTING THE HARD DISK PARTITION
When a hard disk is formatted on the CD3000XL, it is divided into sections called partitions (see
later for details on formatting disks). This makes disk management slightly easier. Depending
on the number of partitions on your disk, the partition is shown as a number A - ? next to the
HARD-: field. You can move the cursor one position to the right to select the partition you wish
to save to. You will see something like this screen:
Use the DATA wheel to make your selection.
SELECTING THE HARD DISK VOLUME
As well as being divided into partitions, each partition is divided into volumes. The volume is
selected in the
below for details on naming volumes). To select the volume, move the cursor to the
and select using the DATA wheel.
SELECTING THE TYPE OF SAVE
The
hard disk). To change the type of save you wish to perform, move the cursor to the
CD3000XL OperatorÕs Manual
or
as appropriate using the DATA wheel.
field (in the above example, it shows that the volume is not named - see
field allows you to select what it is you will save to disk (be it floppy or
field:
S A V E
field and
field
Page 209
Advertisement
Table of Contents
