Restoring Takes Back From Dat To Disk - Akai CD3000XL Operator's Manual

GLOBAL

RESTORING TAKES BACK FROM DAT TO DISK

The take restore functions are found in the DREC page on F7 -
Pressing this gives this screen display:
This page looks very much like the normal record page except that you have lost the threshold
field. To perform a restore of either a single take or all takes, line the DAT up to the appropriate
point and press F8 -
indicating that any takes currently on disk that have the same name as those backed up on DAT
will be overwritten and replaced with those from DAT. Press OK or EXIT as appropriate.
PRESSING 'OK' WILL IRREVOCABLY ERASE THOSE TAKES
Immediately after you press OK, the display will show:
This indicates that the CD3000XL is receiving the digital signal through the digital interface.
You should now start your DAT machine.
If the display shows WAITING FOR CARRIER, this indicates that the correct digital connection
has not been made. Please check your connections and also please check the settings of the
digital interface in the DIGI page of RECORD SET-UP in SAMPLE mode. You may press F8 -
ABORT - to exit this screen.
Page 280
on the CD3000XL. You will receive the following message:
IMPORTANT NOTE:
THAT HAVE THE SAME NAME.
BE VERY CAREFUL IN YOUR SELECTION
. I.e:
CD3000XL OperatorÕs Manual