Individual Call By Manually Entering A Mmsi - Standard Horizon Explorer GX1600 Owner's Manual

9.5.5.2 Individual Call by Manually Entering a MMSI

You may enter an MMSI number manually to contact another vessel.
1. Press the
pear.
2. Press the
cancel, press the
3. Press the
If you have transmitted a Individual call be-
fore, the radio will show the name of the last
person you called as shown in the display at
the right. If this is the case press the
soft key and the following steps.
4. Press the
press the
5. Press the
of the MMSI which you want to contact, then press
the soft key to step to the next number.
6. Repeat step 5 to set the MMSI number (nine digits).
7. If a mistake was made entering in the MMSI num-
ber, repeat pressing the
wrong number is selected, then press the
key to correct the entry.
8. When finished entering the MMSI number, press and
hold the
9. Press the
key to select the operating channel you want to com-
municate on, then press the
channel is not shown in the list, press the
soft key, then press the
operating channel you want to communicate on, then
press the
10. Press the
DSC signal.
11. When an individual call acknowledgment is received,
the established channel is automatically changed
to the channel which is selected on step 5 above
and a ringing tone sounds.
12. Press the
GX1600
key. The "DSC Menu" menu will ap-
/ key to select "INDIVIDUAL". (To
soft key.)
soft key.
NOTE
/ key to select "MANUAL", then
soft key.
/ key to select the first number
soft key.
soft key, then press the
/
soft key.
soft key to transmit the individual
soft key to listen to the channel to
soft key until the
/
/
soft key. If the
key to select the
Page 47