9.9
POSITION REPORT
The feature is similar to Position Request, however instead of requesting a
position of another vessel this function allows you to send your position to
another vessel. Your vessel must have an operating GPS receiver connected
for the GX1600 to send the position.
To transmit a Position Report Call, a GPS must be connected to the
radio and the GX1600 Individual directory must be programmed with
stations you wish to send your position to. To setup this directory refer to
section "9.5.1 Setting up the Individual / Position Call Directory."
9.9.1 Position Report Ringer Setup
The GX1600 has the capability to turn off the Position Report ringer.
1. Press and hold down the
Menu" appears.
2. Press the
SETUP" menu.
3. Press the
BEEP" with the
4. Press the
Report" with the
5. Press the
with the
6. Press the
ting.
7. Press the
To re-enable the ringer tone, repeat the above procedure, pressing the
key to select "On" in step "5" above.
9.9.2 Transmitting a DSC Position Report Call
9.9.2.1 DSC Position Report Call using the Individual Directory
1. Press the
2. Press the
(To cancel, press the
3. Press the
4. Press the
directory, then press the
5. Press the
the selected vessel.
GX1600
/
key to select "DSC
soft key, then select "DSC
/
key.
soft key, then select "POS
/
key.
soft key, then select "Off"
/
key.
soft key to store the selected set-
soft key several times to return to radio operation.
key. The "DSC Menu" will appear.
/
key to select "POS REPORT".
soft key.
/
key to select the name in the
soft key to send your position to
NOTE
key until "Setup
soft key.)
soft key.
/
Page 59