Kohler Command PRO ECH630 Service Manual page 109

NOTE: Always use a fl ywheel puller to remove
the fl ywheel from the crankshaft . Do
not strike the crankshaft or fl ywheel,
as these parts could become cracked
or damaged. Striking the puller or
crankshaft can cause the crank gear to
move, aff ecting crankshaft endplay.
Figure 8-63. Removing Flywheel with a Puller.
5. Remove the woodruff key.
Remove Stator and Backing Plate
1. Remove the four screws securing the backing
plate. See Figure 8-64. Remove the backing plate.
Figure 8-64. Removing Backing Plate.
2. Remove the two hex fl ange screws and the stator.
See Figure 8-65. Note the position/routing of the
stator lead.
Figure 8-65. Removing Stator.
Remove Closure Plate Assembly
1. Remove the ten hex fl ange screws securing the
closure plate to the crankcase. See Figure 8-66.
Figure 8-66. Removing Closure Plate Fasteners.
2. Locate the splitt ing tabs cast into the perimeter
of the closure plate. Insert the drive end of a
1/2 in. breaker bar between the splitt ing tab and
the crankcase and turn it to loosen the seal. See
Figure 8-67. Do not pry on the sealing surfaces as
this can cause leaks.
Section 8
Disassembly
8
8.15