Kohler Command PRO ECH630 Service Manual page 100

Section 8
Disassembly
Figure 8-20. Remove Inlet Fuel Line and Oetiker
Clamp.
3. Disconnect the yellow electrical connector by
pulling up on the grey tab to release. See Figure
8-21.
Figure 8-21. Disconnect Electrical Connector.
4. Wrap a shop towel completely around the high
pressure fuel line connector.
5. Press the release butt on(s) and slowly pull the
connector away from the fuel pump module,
allowing the shop towel to absorb any residual
fuel in the high pressure fuel line. Any spilled
fuel must be completely wiped up immediately.
See Figure 8-22.
8.6
Grey Release Tab Grey Release Tab
Figure 8-22. Slowly Pull Connector.
NOTE: Figure 8-22 depicts removing the connector
without a shop towel wrapped around it for
instructional purposes only.
6. Disconnect the vent hose from the top of the fuel
pump module.
7. Remove the screws securing the fuel pump
module baffl e which the pump was mounted to.
Remove Throttle Body
1. Disconnect the breather tube from the thrott le
body. See Figure 8-23.
Figure 8-23. Disconnecting the Breather Tube.
2. Disconnect the intake air temperature sensor
from the thrott le body. See Figure 8-24.
Release Button Release Button