Kohler Command PRO ECH630 Service Manual page 105

Figure 8-44. Disconnecting Electrical Connector.
Remove the Manifold Absolute Pressure
(MAP) Sensor
1. With a screwdriver, slide the locking tab on the
electrical connector. See Figure 8-45.
Slide Slide
Locking Locking
Tab Tab
Figure 8-45. Slide Locking Tab on Connector.
2. Detach the connector.
3. Remove the hex fl ange screw and pull the MAP
sensor out of the intake manifold. See Figure 8-46.
Figure 8-46. Removing MAP Screw.
Remove Fuel Injectors
1. Disconnect the electrical connector. See Figure 8-47.
Electrical Electrical
Connector Connector
Figure 8-47. Disconnecting Electrical Connector.
2. Remove the hex fl ange screw and pull the injector
Figure 8-48. Removing Fuel Injectors.
3. When removed, pull the metal retaining clip
out of the intake manifold for each injector. See
Figure 8-48.
connecting the fuel injector to the fuel injector
cap. See Figure 8-49. There may be some fuel left
in the line. Any spilled fuel must be cleaned up
immediately.
Section 8
Disassembly
8
8.11