Os8-10Gni-Ur1 Front Panel - Alcatel OMNISWITCH 8800 Getting Started Manual

OS8-10GNI-UR1 Front Panel

Module Status LEDs
OK1. Hardware Status. Displays solid
green when powered on and the 10GNI has
passed hardware diagnostic tests. Displays
solid amber when powered on and the
10GNI has failed hardware diagnostic tests.
OK2. Software Status. Blinks green when
the 10GNI is operational and has success-
fully loaded software. Displays solid amber
when powered on and the 10GNI has failed
to load software.
Gigabit Ethernet Port LEDs
Tx. Transmit Status. On the active port this
will LED will blink green when it is trans-
mitting data. On the inactive port this LED
will always be off.
Rx. Receive Status. On the active port this
will LED will blink green when it is receiv-
ing data. On the inactive port this LED will
always be off.
Link. Link Status. This LED will be solid
green if there is a Xenpak module plugged
into the port.
March 2005
OK1
Module
Status
OK2
LEDs
Tx
Rx
Link
1
Port
Redundancy
Tx
Rx
Link
2
10 Gigabit Ethernet Ports
The OS8-10GNI-UR1 module provides 2 Xenpak
slots, which act as one redundant port. These slots sup-
port the following Xenpak types:
•
OM-10GNI-SR—10GBASE-S Multimode fiber,
supports distances up to 300 meters; uses SC
connectors.
•
OM-10GNI-LR—10GBASE-L Single mode
fiber, supports distances up to 10 km; uses SC
connectors.
•
OM-10GNI-ER—10GBASE-E single mode
long haul fiber, supports distances up to 40 km;
uses SC connectors.
Note
Refer to your OmniSwitch 8800 Hardware Users
Guide for information on proper handling of SC con-
nectors and fiber-optic cable.
Hardware Basics 63