Cli Basics; Cli Assistance Features; Syntax Checking - Alcatel OMNISWITCH 8800 Getting Started Manual

CLI Basics

The Command Line Interface (CLI) allows you to configure
and monitor your switch by entering single-line commands.
The CLI can be accessed through terminal or Telnet sessions.
Note. Configuring the switch using the CLI is also
referred to as "online configuration."
The following section provides basic information on CLI
assistance features. For detailed information on the CLI,
including syntax conventions, usage rules, command docu-
mentation, and a quick reference card, refer to the OmniSwitch
CLI Reference Guide and the OmniSwitch 7700/7800/8800
Switch Management Guide.

CLI Assistance Features

The CLI provides built-in features that assist you while enter-
ing commands. These features include:

Syntax checking

•
Command line help
•
Partial keyword completion
•
Deleting and inserting characters
•
Previous command recall
•
Prefix recognition
•
Prefix prompt
•
Command history
•
March 2005
Note. The software supports vt100 terminal emulation;
CLI assistance features may be limited if your terminal
emulation software is using a setting other than vt100.
Syntax Checking
If you make a mistake while entering command syntax, the
CLI provides clues about how to correct the error. Whenever a
command error is entered, two indicators are displayed:
An Error message describing the type of error.
•
A carat (^) character indicating where the error
•
occurred.
For example, the syntax
-> show vlan router port mac status
results in the following error:
-> show vlan router port mac status
ERROR: Invalid entry: "port"
Because port is not valid syntax for the command, the error
message shows it as an invalid entry and the carat indicates
where the problem has occurred. For this example, the valid
command syntax is
-> show vlan router mac status
^
CLI Basics 31