Common Cli Commands - Alcatel OMNISWITCH 8800 Getting Started Manual

Common CLI Commands

The following table lists some basic CLI commands that will
help you get acquainted with the CLI interface. Enter each
command exactly as shown. For complete descriptions of
these commands, refer to your OmniSwitch CLI Reference
Guide.
write memory
show running-directory
vlan
show vlan
ip interface
show chassis
show module
show ni
36 CLI Basics
Saves current configuration
changes to the /flash/working
directory's boot.cfg file. For more
information, refer to page
Displays the current running direc-
tory. For more information, refer to
page 40.
Creates a new VLAN.
Displays a list of VLANs config-
ured on the switch.
Configures an IP interface to
enable IP routing on a VLAN.
Displays basic configuration and
status information for the switch
chassis.
Displays basic information for all
modules installed in the chassis.
Modules include primary and sec-
ondary CMMs and Network Inter-
face (NI) modules.
Displays basic hardware and status
information for NI modules
installed in the switch.
show cmm
show fabric
show system
show microcode
38.
exit
session timeout
Displays basic hardware and status
information for CMM modules in
the chassis.
Displays the status and configura-
tion of Switch Fabric Modules
(SFMs).
Displays basic information about
the switch.
Displays the version of software
currently installed on the switch.
Ends the current Telnet or console
session.
Modifies the amount of time before
Telnet and console sessions will
time out.
March 2005