Installing Minigbic Connectors - Alcatel OMNISWITCH 8800 Getting Started Manual

Installing MiniGBIC Connectors

If you are installing an OS8-GNI-U8 or OS8-GNI-U24
module, you must install Miniature Gigabit Interface Convert-
ers (MiniGBICs) as required. These MiniGBICs are packaged
separately.
MiniGBIC Module
To install a MiniGBIC follow the steps below.
1 Be sure you have eliminated ESD by using the
provided grounding wrist strap. Refer to
Grounding Wrist Strap and Chassis Grounding Lug" on
page 12 for more information.
2
Holding the MiniGBIC by its sides, carefully slide it
into the desired GNI module universal MiniGBIC slot.
16 Installing the Hardware
"Using the
3
Push the MiniGBIC into the slot until it clicks into
place.
GNI Module
MiniGBIC Slot
MiniGBIC Module
Note. There is a small removal handle at the front of the
MiniGBIC transceiver. To remove a MiniGBIC, carefully
lift this handle; then, grasp the handle and carefully pull
the MiniGBIC from the module.
Caution. The MiniGBIC should slide in easily. Do not
force it into the slot. If any resistance is encountered,
ensure the MiniGBIC is aligned properly. Forcing the
MiniGBIC into the slot can damage the unit, as well as
components on your GNI module.
March 2005