Cmm Front Panel - Alcatel OMNISWITCH 8800 Getting Started Manual

CMM Front Panel

Module Status LEDs
OK1. Hardware Status. Displays solid green when powered on
and the CMM has passed hardware diagnostic tests. Displays
solid amber when powered on and the CMM has failed hardware
diagnostic tests.
OK2. Software Status. Blinks green when the CMM is opera-
tional. Displays solid amber when a system software failure
occurs. Blinks amber when the software is in a transitional state
(e.g., when software is being downloaded to the switch).
Temperature/Fan Status LEDs
TEMP. Displays solid green when the CMM is operating within
the allowed ambient temperature range. Displays solid amber if a
temperature error occurs (i.e., the CMM is operating outside the
temperature range).
STATUS. Displays solid green when the Switch Fabric Modules
(SFMs) and power supplies are operating normally. Displays solid
amber if there is an error in an SFM or power supply.
FAN 1. Displays solid green when the two fans in the left front
fan tray are running at normal speed. Displays solid amber if a fan
error occurs (i.e., one or more fans are not running at normal
speed).
FAN 2. Displays solid green when the two fans in the right front
fan tray are running at normal speed. Displays solid amber if a fan
error occurs (i.e., one or more fans are not running at normal
speed).
FAN 3. Displays solid green when the three fans in the rear fan
tray are running at normal speed. Displays solid amber if a fan
error occurs (i.e., one or more fans are not running at normal
speed).
March 2005
OK1
OK2
Module
Status
PRI LEDs
SEC
Module
Status
TEMP
LEDs
STATUS
1
2 FAN
3
CONSOLE
/ MODEM
ENET
LINK
ACT
Redundancy LEDs
PRI. Displays solid green when the CMM is the
primary (active) management module.
SEC. Displays solid green when the CMM is the
secondary (backup) management module.
Ethernet Management Port LEDs
LINK. Link Integrity Status. Displays solid green
when an Ethernet cable connection exists at the
CMM's Ethernet Management Port.
ACT. Flashes green as data is transmitted or
received on the CMM's Ethernet Management Port.
Console/Modem Port. The CMM's front panel
provides one RS232 port for console or modem
connections. By default, this female DB-9 connec-
tor provides a DCE console connection. However,
by changing the onboard jumper setting, the port
can be changed to a DTE modem connection.
Ethernet Management Port (EMP). The CMM's
front panel also provides one Ethernet 10/100BaseT
port (copper RJ-45). This port provides out-of-band
network management and can be used for Telnet
sessions, switch diagnostics, and for downloading
software to the switch.
This 10/100BaseT port supports both 10BaseT and
100BaseT with auto-negotiation through the RJ-45
connector.
Hardware Basics 53