Booting The Switch; Component Leds - Alcatel OMNISWITCH 8800 Getting Started Manual

Booting the Switch

Now that you have installed the switch components and
connected all required cables, you can boot the switch. To boot
the switch, simply turn the on/off switch for all installed power
supplies to the on ( | ) position.
Note. If you have more than one power supply installed,
be sure to turn on each power supply in rapid succession,
(i.e., within a few seconds of each other). This ensures that
there will be adequate power for all NI modules when they
boot.

Component LEDs

The boot process takes a few moments to complete. During
this process, the LEDs on the CMM, SFM, and NI modules
may flash and change color, indicating different stages of the
boot.
Following a successful boot, the LEDs on all switch compo-
nents, including power supplies, should display as follows:
CMM OK1
CMM OK2
CMM TEMP
CMM FAN 1
22 Booting the Switch
Solid Green
Blinking Green
Solid Green
Solid Green
CMM FAN 2
CMM FAN 3
SFM OK1
SFM OK2
NI OK1
NI OK2
Power Supply TEMP Fail
Power Supply DC OK
Power Supply AC OK
If the LEDs do not display as indicated, make sure the boot
process is completed. Again, the boot process takes several
moments to complete. If the LEDs do not display as indicated
following a complete boot sequence, contact Alcatel Customer
Support.
For descriptions of CMM, SFM, and NI LED states, see pages
53 through 63. For information on power supply LED states,
refer to the OmniSwitch 8800 Hardware Users Guide.
Once the switch has completely booted and you have accessed
your computer's terminal emulation software via the console
port, you are ready to log in to the switch's Command Line
Interface (CLI) and configure basic information. Continue to
"Your First Login Session" on page
Solid Green
Solid Green
Solid Green
Blinking Green
Solid Green
Blinking Green
Off
Solid Green
Solid Green
23.
March 2005