Alcatel OMNISWITCH 8800 Getting Started Manual page 21

3
When the module is nearly seated in the slot, be sure
that the two extractor levers—one on top of the module
and one on the bottom—are slightly opened (approxi-
mately 30 degrees). This allows the notch on each extrac-
tor lever to grasp the rail on the chassis. Once the notches
have grasped the rail, press both extractor levers simulta-
neously until the module is firmly seated.
March 2005
4
Once the module is firmly seated, secure the module to
the chassis by tightening the two captive screws. Be sure
not to overtighten the captive screws. If you use a screw-
driver, the torque used to tighten the screws must not
exceed 2.3 inch pounds.
5 Install all remaining modules by repeating steps 1
through 4 for each module.
Installing the Hardware 15