Mitsubishi Electric MELSEC Q Series User Manual page 84

(4) When using the slim type main base unit (Q3 SB)
(a) System configuration
Battery for QCPU (Q6BAT)
Q7BAT-SET
Battery holder Battery for QCPU (Q7BAT)
4
Q8BAT-SET *
Q8BAT connection cable Battery for QCPU (Q8BAT)
*1: One memory card is installed. Select an appropriate memory card from the SRAM, Flash and ATA cards according to the
application and capacity.
When the memory card is used, operation is not guaranteed.
*2: The slim type main base unit does not have an extension cable connector.
The extension base unit and GOT cannot be bus-connected.
*3: As a power supply module, use the slim type power supply module.
Keep the current consumption within the rated output current of the power supply module.
The Q series power supply module and the redundant power supply module are not available for the power supply
module.
*4: When the Q8BAT is used for the Universal model QCPU, use the connection cable whose connector part displays "A".
For details of connector part of a connection cable, refer to the following manual.
QCPU User's Manual (Hardware Design, Maintenance and Inspection)
*5: For memory cards that can be used with the C Controller module, refer to the manual of the C Controller module.
●
When the multiple CPU system is configured using the Q00UCPU, Q01UCPU, Q02UCPU as the CPU No.1, only the
following CPU module can be used as the CPU No.2.
• C Controller module
●
When the multiple CPU system is configured using the Universal model QCPU (except Q00UCPU, Q01UCPU,
Q02UCPU) as the CPU No.1, only the following CPU modules can be used as the CPUs No.2 and 3.
• High Performance model QCPU
• Universal model QCPU (except Q00UCPU, Q01UCPU, Q02UCPU)
• C Controller module
Memory card * 1
Figure 2.21 System configuration when Q3 SB is used
CHAPTER2 SYSTEM CONFIGURATION
High Performance
C Controller
model QCPU 5
module *
Universal model
QCPU
Slim type main base unit *
Slim type power supply/input/output/
intelligent function module
2, 3
*
2 - 36
1
2
3
4
5
6
7
8