Mitsubishi Electric MELSEC Q Series User Manual page 59

*1: Only one memory card can be mounted. Select an appropriate memory card from the SRAM, Flash and ATA in
accordance with application and capacity.
When a commercial memory card is used, the operation is not guaranteed.
*2: Use the Q series power supply module for the power supply module. Keep the current consumption within the rated
output current of the power supply module. The Slim power supply module and Redundant power supply module are not
available for the power supply module.
*3: Use of the Process CPU or the Universal model QCPU in combination with the AnS/A series compatible power supply
module, the I/O module and the special function module is not allowed.
( Refer to Section 7.1)
*4: The Q Series power supply module is not required for the Q5 B extension base unit.
*5: The motion CPU and PC CPU module do not accept battery for QCPU and memory card.
*6: For further information on PC CPU module, consult CONTEC Co., Ltd Tel: +81-6-6472-7130
*7: Be sure to set the control CPU of the motion module to the Motion CPU.
*8: The PC CPU module and C Controller module cannot be mounted together.
*9: When mounting the Universal model QCPU and the PC CPU module at the same time, use the PPC-CPU852 (MS)-512
as the PC CPU module.
*10: The Q00UCPU, Q01UCPU, Q02UCPU cannot be mounted.
The Universal model QCPU (except Q00UCPU, Q01UCPU, Q02UCPU) and the Motion CPU (Q172CPUN(-T),
Q173CPUN(-T), Q172HCPU(-T), and Q173HCPU(-T)) cannot be mounted at the same time.
*11: When the Q8BAT is used for the Universal model QCPU, use the connection cable whose connector part displays "A".
For details of connector part of a connection cable, refer to the following manual.
QCPU User's Manual (Hardware Design, Maintenance and Inspection)
*12: The QA6ADP+A5 B/A6 B is available. However, when using the QA1S6 B, the QA6ADP+A5 B/A6 B cannot be
connected.
When the multiple CPU system is configured using the High Performance model QCPU or the Process CPU as the CPU
No.1, only the following CPU modules can be used as the CPUs No.2 to No.4.
• High Performance model QCPU
• Process CPU
• Universal model QCPU (except Q00UCPU, Q01UCPU, Q02UCPU)
• Motion CPU(Q172CPUN(-T),Q173CPUN(-T),Q172HCPU(-T),Q173HCPU(-T))
• PC CPU module
• C Controller module
Note that the multiple CPU system cannot be configured using the following combinations.
• Combination of the Universal model QCPU (except Q00UCPU, Q01UCPU, Q02UCPU) and the Motion CPU
(Q172CPUN(-T), Q173CPUN(-T), Q172HCPU(-T), Q173HCPU(-T))
• Combination of the Universal model QCPU (except Q00UCPU, Q01UCPU, Q02UCPU) and the PC CPU module
(PPC-CPU686(MS)-64, PPC-CPU686(MS)-128)
• Combination of the PC CPU module and the C Controller module
2 - 11