Zoom X7N User Manual page 12

8 After you log in use the Basic Setup page to configure the
modem so it can connect with your Internet service provider
•
We recommend you use Automatic Configuration to set
up your ADSL connection unless you have requested and
typically paid for a Static IP from your service provider.
To use Automatic Configuration (recommended):
a
Under Automatic Configuration, click Start.
b
If the X7N finds a PPPoE or PPPoA connection,
enter the user name and password given to you by
your Internet Service Provider. (Your provider should
have given you a User ID or User Name, usually
your email address or the characters preceding the @
sign in your email address, and a Password. These are
NOT the User ID and Password that you used to get
into the Zoom Configuration Manager.)
Note: Remember that these terms are case-sensitive.
Pay careful attention to whether you're using a capital
or small letter, a zero or the letter O, and so on.
Clearly write down and store the User Name and
Password, on the bottom of the X7N case, for
instance, and in a ModemSettings file.
c
Click Save/Apply.
•
If Automatic Configuration does not work or in the unlikely event
you are using a Static IP you can configure your settings
manually by following these instructions:
a
On the Basic Setup page, enter your Protocol,
Encapsulation, VPI, and VCI settings in the
appropriate boxes. Your service provider should
supply these values. If you do not know these settings,
refer to the tables starting on page 70.
b
Depending on the Protocol setting you selected the
bottom half of the page will change so that you can
enter additional information.
•
If you selected PPPoA or PPPoE, enter
your ADSL User Name and Password in
the appropriate boxes. Your Internet service
provider should have given this information
to you. (Your User Name is typically your
Chapter 1: Installation Instructions X7N User Manual