Drilled Paper; Letterhead; Non-Standard Size Paper; Auto Tray Switching - Xerox DocuColor 6060 Operator's Manual

P P T
A P E R A N D A P E R R A Y S

Drilled Paper

Letterhead

Non-Standard Size Paper

Auto Tray Switching

3- 8
3-hole drilled paper can be run from all the trays either LEF or SEF with the holes
facing any direction.
NOTE:
If you are stapling 3-hole drilled paper with the optional High Capacity
Stacker Stapler, refer to the Accessories chapter for paper loading instructions,
based on the position of the staple.
Different inks and dry inks/toners are used to produce preprinted letterhead that
may not pass through the digital press intact.
Refer to the Specialty Media Guide: Hints and Tips for information on using
preprinted letterhead paper.
Non-Standard size paper is identified as any paper for which there is no paper
guide setting within the minimum and maximum sizes for the trays: 7.16 to 12.6
LEF or 7.16 to 19.2 SEF (182 - 320mm LEF or 182 x 488mm SEF)
Non-Standard size paper can be loaded into all the trays. The Non-Standard
setting must be selected on the top/front of the paper tray. Refer to the System
Administration Guide for the procedure to program a Non-Standard size paper to
be the default setting for a particular tray.
When Auto Tray Switching (ATS) is activated in the Tools Mode, the digital press
automatically switches to another tray containing paper of the identical size,
weight, type, and feeding orientation (SEF or LEF) when the tray being used is
empty. Refer to the System Administration Guide for the instruction on enabling
ATS.
6 0 60
D O C U C O L O R O P E R A T O R M A N U A L