D
C
6 0 60 O
O C U
O L O R
P E R A T O R
Undocking the HCSS
To undock the HCSS from the digital press, reach into the circular area near the
bottom of the HCSS for the Undocking Lever. Refer to the picture below.
Undocking
Lever inside
here
Pull the lever toward you and hold it in position while moving the HCSS a small
distance (25.4mm, 1") away from the press. Release the lever and continue to
move the HCSS as far as required.
Loss of Power
If power is interrupted to the High Capacity Stacker Stapler:
• Ensure the power cord is plugged in to the proper wall receptacle.
• Ensure that the digital press power is on.
• If the power has not been restored by the above procedure, call Xerox
Customer Support.
Also call your Xerox service representative if the loss of power to the High
Capacity Stacker seems to be frequent or excessive.
M
A N U A L
Figure 48. HCSS Undocking Lever
A
C C E S S O R I E S
5-65