Selecting Features; Obtaining A Sample Set; With One Stacker - Xerox DocuColor 6060 Operator's Manual

A
C C E S S O R I E S

Selecting Features

5- 1 6
Use the following instructions to select the HCS when using the digital press
scanner to make prints.
If sending a job through the network, refer to the documentation that came with
your color server for information on how to select stacker options on the print
driver screens.

Obtaining a Sample Set

Occasionally you may want to check the image quality during a long run of a print
job. You can accomplish this by obtaining a Sample Set, before the job is done.

With One Stacker

To obtain a Sample Set, open the lid of the keypad on the HCS and press the #
key, then the 1 key. The system will complete the set being stacked, then send
the next set to the Top Tray.
KEY POINT:
A digital press fault may occur if you request a sample set in the
following situations:
• Requesting a sample set before the first sheet of a set reaches the Stack
Tray, or
• The output destination is other than the Stack Tray of the HCS from which
the request was programmed.
1
Touch the Settings button on in the Output column of the Basic Features screen.
Figure 13. Basic Features Screen with Stacker Selected
D C 6 06 0 O
O C U O L O R P E R A T O R
M
A N U A L