Remote Node Filter; Figure 16-8 Menu 11.4: Remote Node Script; Table 16-7 Menu 11.4: Remote Node Script - ZyXEL Communications P-324 User Manual

Prestige 324 User's Guide
The following table describes the fields in this menu.

Table 16-7 Menu 11.4: Remote Node Script

FIELD
Active Press [SPACE BAR] and then [ENTER] to select either Yes to enable the
AT strings or No to disable them.
Set 1-6: Enter an Expect string to match. After matching the Expect string, the
Expect Prestige returns the string in the Send field.
Set 1-6: Enter a string to send out after the Expect string is matched.
Send

16.9 Remote Node Filter

Move the cursor to the field Edit Filter Sets in menu 11.1, and then press [SPACE BAR] to set the value to
Yes. Press [ENTER] to open Menu 11.5 - Remote Node Filter.
Use menu 11.5 to specify the filter set(s) to apply to the incoming and outgoing traffic between this remote
node and the Prestige to prevent certain packets from triggering calls. You can specify up to four filter sets
separated by commas, for example, 1, 5, 9, 12, in each filter field. Note that spaces are accepted in this field.
Please refer to the Filters chapter for more information on defining the filters.
16-12
Menu 11.4 - Remote Node Script
Active= No
Set 1:
Expect=
Send=
Set 2:
Expect=
Send=
Set 3:
Expect=
Send=
Set 4:
Expect=
Send=
Enter here to CONFIRM or ESC to CANCEL:

Figure 16-8 Menu 11.4: Remote Node Script

DESCRIPTION
Set 5:
Expect=
Send=
Set 6:
Expect=
Send=
EXAMPLE
No
(default)
0.0.0.0
Menu 2 WAN Setup