Figure 20-2 Menu12.1 Edit Ip Static Route; Table 20-1 Menu12.1 Edit Ip Static Route - ZyXEL Communications P-324 User Manual

Prestige 324 User's Guide
The following table describes the fields for Menu 12.1 – Edit IP Static Route Setup.
FIELD
Route #
Route Name
Active
Destination IP
Address
IP Subnet Mask
Gateway IP Address
Metric
20-2
Menu 12.1 - Edit IP Static Route
Route #: 1
Route Name= ?
Active= No
Destination IP Address= ?
IP Subnet Mask= ?
Gateway IP Address= ?
Metric= 2
Private= No
Press ENTER to Confirm or ESC to Cancel:

Figure 20-2 Menu12.1 Edit IP Static Route

Table 20-1 Menu12.1 Edit IP Static Route

This is the index number of the static route that you chose in menu 12.1.
Type a descriptive name for this route. This is for identification purpose only.
This field allows you to activate/deactivate this static route.
This parameter specifies the IP network address of the final destination. Routing
is always based on network number. If you need to specify a route to a single
host, use a subnet mask of 255.255.255.255 in the subnet mask field to force the
network number to be identical to the host ID.
Type the subnet mask for this destination. Follow the discussion on IP Subnet
Mask in this manual.
Type the IP address of the gateway. The gateway is an immediate neighbor of
your Prestige that will forward the packet to the destination. On the LAN, the
gateway must be a router on the same segment as your Prestige; over WAN, the
gateway must be the IP address of one of the remote nodes.
Metric represents the "cost" of transmission for routing purposes. IP routing uses
hop count as the measurement of cost, with a minimum of 1 for directly connected
networks. Type a number that approximates the cost for this link. The number
need not be precise, but it must be between 1 and 15. In practice, 2 or 3 is usually
a good number.
DESCRIPTION
Static Route Setup