Nat Setup; Figure 21-2 Menu 11.3 Applying Nat To The Remote Node - ZyXEL Communications P-324 User Manual

Figure 21-2 Menu 11.3 Applying NAT to the Remote Node

The following table describes the options for Network Address Translation.
FIELD
NAT Press [SPACE BAR] and then [ENTER] to select Full Feature if you
have multiple public WAN IP addresses for your Prestige. The SMT
uses the address mapping set that you configure and enter in the
Address Mapping Set field (menu 15.1 - see section 21.3.1).
Select None to disable NAT.
When you select SUA Only, the SMT uses Address Mapping Set 255
(menu 15.1 - see section 21.3.1). Choose SUA Only if you have just
one public WAN IP address for your Prestige.

21.3 NAT Setup

Use the address mapping sets menus and submenus to create the mapping table used to assign global
addresses to computers on the LAN. Set 255 is used for SUA. When you select Full Feature in menu 4 or
11.3, the SMT will use Set 1. When you select SUA Only, the SMT will use the pre-configured Set 255
(read only).
The server set is a list of LAN servers mapped to external ports. To use this set, a server rule must be set up
inside the NAT address mapping set. Please see the section on port forwarding in the chapter on NAT web
NAT
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment= Dynamic
IP Address= N/A
IP Subnet Mask= N/A
Gateway IP Addr= N/A
Network Address Translation= SUA Only
Metric= 1
Private= N/A
RIP Direction= None
Version= N/A
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
Table 21-1 Applying NAT in Menus 4 & 11.3
DESCRIPTION
Prestige 324 User's Guide
EXAMPLE
Full Feature
None
SUA Only
21-3