OneWireless™ Series User Manual
6. 5BMaintenance/Repair
6.2. Replacing Antenna
Step
Action
15
If the unit removal or re-installation caused the input shaft to be rotated enough to make the internal slip clutch
slip, then re-setting the device angle must be performed (see section 3).
16
For elbow type antenna, adjust antenna for best reception. Don't rotate antenna more than 180 degrees either
direction or you could twist and break the antenna wiring inside. Tighten the antenna locking set screw (10).
Figure 17. Antenna replacement
42
Honeywell Sensing and Control
50040849
Issue 3