Preparation; Battery Connecting Procedure; Table 1 Battery Connecting Procedure - Honeywell XYR 6000 User Manual

OneWireless™ Series User Manual

3. Preparation

3.1

Battery Connecting Procedure

WARNING
RISK OF DEATH OR SERIOUS INJURY FROM
EXPLOSION OR FIRE
Connection and disconnection of the batteries should only
be performed in a non-hazardous area.
Failure to comply with these instructions could result
in death or serious injury.
WARNING
RISK OF DEATH OR SERIOUS INJURY FROM
EXPLOSION OR FIRE
If sensor is to be returned to Honeywell for any reason,
both batteries MUST be removed prior to shipping.
Dispose of used batteries promptly per local regulations or
the battery manufacturer's recommendations. Keep away
from children. Do not disassemble and do not dispose of in
fire.
Failure to comply with these instructions could result
in death or serious injury.
ATTENTION
Both batteries must be the same model from the same manufacturer. Mixing
old and new batteries or different manufacturers is not permitted.
Use only the following 3.6V lithium thionyl chloride (Li-SOCl2) batteries (non-
rechargeable), size C. No other batteries are approved for use in WCX Series
Valve Position Sensors.
•
Xeno Energy XL-145F
•
Tadiran TL-5920/S
Table 1. Battery Connecting Procedure (For item numbers, refer to Figures 2 and 3)
Step Action
1 If applicable, remove two T-15 TORX screws (1) and cover lock clamp (2).
2 If necessary, place a large screwdriver or other flat tool across the two tabs on the cover (3). Unscrew
and remove the cover.
3 Using two fingers, press down slightly on both battery tops (4) and remove battery insulator (5). Insure
that the batteries are properly seated and making good contact.
4 Replace cover, tightening hand tight. If applicable, replace cover lock clamp (2) and two T-15 TORX
screws (1).
50040849
Issue 3
3. 2BPreparation
3.1. Battery Connecting Procedure
Honeywell Sensing and Control 9