Advertisement
RF6GB LEDs
The RF6GB has three LEDs which are visible
when the unit is mounted.
Green 1 LED indicates device enrollment and
tamper status.
The Red and Green 2 LEDs provide information
on detector status during Test Mode. The Green
2 LED indicates events and the Red LED
indicates Alarms.
LED Indications Table
G1
Red
3
1
If RF6GB Test Mode is activated by the FG701, the Green 2 LED will flicker, then be off for 3 seconds, then flash once per second.
2
Test Mode lasts for 10 minutes.
3
This feature is used for field diagnosis. The LEDs are not visible during Normal Mode to save power.
Test the RF6GB
The RF6GB should be tested after installation and at least
once a year.
Test Mode can be activated remotely from the Control
Panel (see Control Panel manual), or on-site with an FG-
701 Glassbreak Simulator, only when the system is
disarmed
.
Follow directions in the FG-701 Glassbreak Simulator
Operating Instructions to activate and test the RF6GB
detector.
Battery Replacement
•
Twist the front cover counterclockwise 15
degrees and separate from the mounting
bracket.
•
Remove and replace the battery.
Recommended replacement batteries:
Panasonic CR123A
Duracell DL123
•
Reattach the front cover and twist it 15
degrees clockwise to lock it in place.
BATTERY CAUTION: Risk of fire, explosion and burns.
Do not recharge, disassemble, heat above 100° C (212° F)
or incinerate. Dispose of used batteries promptly. Keep
away from children.
G2
Status
2
Test Mode
1
Event detected during Test Mode
Alarm detected during Test Mode
Low Battery detected during Test Mode
3
Power Up / Tamper switch pressed / FG-701 Activated before enrollment
Tamper Detected
Honeywell 466
Duracell DL123A
Advertisement
