Honeywell XYR 6000 User Manual page 36

OneWireless™ Series User Manual
5. 4BOperation
5.6. Authentication Device
To connect your sensor to the OneWireless network perform the following steps.
Step
1
If the PDA contains no keys, obtain new security keys from the PC application Key Server Manager.
To do this, select Receive Security Keys. Keys can be received either through Infrared (by aiming PDA at
the infrared dongle) or through an ActiveSync/USB connection. See Key Server Communication Method
under Advanced options on page 34 for details.
Important: The Comm Method settings must match in the PC's Key Server Manager and in the
Authentication Device (both must be set to Infrared or both to ActiveSync) in order for your PDA to receive
security keys. See Key Server Communication Method under Advanced options on page page 34 for
details.
2
When the Authentication Device has valid unexpired keys, aim it at the sensor and transmit a key to the
sensor. The sensor will validate the key and then use it to make a connection to the OneWireless
Network. The Sensor may continue to show the diagnostic message "NO KEY" for a brief time while it
validates the key before showing the "DISCOVER" message.
To verify your sensor has been authenticated, see the Connection prompt on the Read Node Info screen
(page 32).
To decommission your sensor from the OneWireless network, select Clear Key and Restart Node. This clears
the sensor's key, network and security configurations, and resets the sensor to its factory default settings. Perform
the following steps.
Select Clear Keys from Handheld (under Advanced Options) when:
•
The PDA has keys from one system, but you have moved your authentication device to another system, or
•
You want to clear all keys so that you cannot deploy any more keys without going to the key server manager
and getting more.
For more details on keys, refer to Getting Started with Honeywell OneWireless Solutions.
30 Honeywell Sensing and Control
Issue 3
Action
50040849