Sensor Connection Status; Table 7 Wcx Series Sensor Connection Status - Honeywell XYR 6000 User Manual

OneWireless™ Series User Manual
5.2

Sensor Connection Status

Table 7. WCX Series sensor connection status
Displayed Definition
status
NO KEY Sensor needs a key from the authentication
device and is not transmitting.
NOT CONN Sensor is in between discovery attempts.
DISCOVER Sensor has not made a connection to a
multinode and is in discovery (searching for
a connection to a multinode). Sensor will
automatically enter a power saving mode if
it cannot make a connection and will retry
later.
SECURING Sensor has connected with the network and
is validating its key.
CONNECTD Sensor has validated the key and has made
a secure connection with at least two
multinodes. Sensor should appear in
wireless builder as an uncommissioned
device.
NO REDUN No redundancy, that is, sensor has
connected with only one multinode.
What to do
Transmit a key to the sensor. See page 29.
If sensor does not make a connection within five minutes, do
the following:
• Check that key is correct for the network you are trying to
join.
Check that multinode(s) in the local area are turned on
•
and are already a secure part of the network.
Check if keyserver is active.
•
• Check the keyserver event log to see if the sensor is
actively trying to join. Errors in the event log show that the
sensor is trying to join but that there are problems. Consult
the OneWireless wireless builder documentation for
troubleshooting errors.
Wait for connection. If sensor does not make a connection
within five minutes, see NOT CONN in this table.
Wait for connection. If sensor does not make a connection
within five minutes, see NOT CONN in this table.
No action required.
No action required. The sensor will periodically look for a
second multinode in order to form a redundant connection to
the network
Honeywell Sensing and Control
50040849
Issue 3
5. 4BOperation
5.2. Sensor Connection Status
23