Figure 4. Elbow Antenna Adjustment; Figure 5. Integral Straight Antenna - Honeywell XYR 6000 User Manual

One wireless series wcx series valve position sensor

Hide thumbs Also See for XYR 6000:

Table of Contents

OneWireless™ Series User Manual

3. 2BPreparation

3.3. Antenna Adjustment and Mounting

Elbow

•

Figure 4. Elbow antenna adjustment

If your model has the integral elbow antenna you can adjust it to improve reception. The least signal radiation is in a

direction in line with the top (pointed end), so it is best to avoid having the antenna pointed directly toward, or

directly away from, the multinode. Typically, pointed straight up gives best performance but your installation may

vary. Loosen the 1,5 mm [approx. 1/16 in] set screw located near the antenna base. Rotate antenna for best

reception. Do not rotate antenna more than 180 degrees either direction or the internal antenna cable could be

damaged. Tighten set screw.

Straight

•

If your model has the integral straight antenna you can adjust its position by rotating the sensor housing. (See

Section 2). Typically, pointed straight up gives best performance but your installation may vary.

Honeywell Sensing and Control

50040849

Issue 3

Table of Contents