Agency Compliance Information; Fcc Compliance Statements; Ic Compliance Statements; Radio Frequency (Rf) Statement - Honeywell XYR 6000 User Manual

OneWireless™ Series User Manual
2.3

Agency Compliance Information

This section contains the Federal Communications Commission (FCC), Industry Canada (IC) and Radio
Frequency compliance statements for the OneWireless Multinode device.
ATTENTION
WCX Series valve position sensor units must be professionally installed in accordance with the
requirements specified in the OneWireless XYR6000 Agency Compliance Professional Installation
Guide.

FCC compliance statements

This device complies with Part 15 of FCC Rules and Regulations. Operation is subject to the following
•
two conditions: (1) This device may not cause harmful interference and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
•
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radiofrequency
energy and, if not installed and used in accordance with these instructions, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own
expense.
Intentional or unintentional changes or modifications must not be made to the Multinode unless under
•
the express consent of the party responsible for compliance. Any such modifications could void the
user's authority to operate the equipment and will void the manufacturer's warranty.

IC compliance statements

To reduce potential radio interference to other users, the antenna type and its gain should be so chosen
•
that the equivalent isotropic radiated power (EIRP) is not more than that permitted for successful
communication.
Operation is subject to the following two conditions: (1) this device may not cause interference, and (2)
•
this device must accept any interference, including interference that may cause undesired operation of
the device.
This Class A digital apparatus complies with Canadian ICES-003.
•
French: Cet appareil numérique de la classe A est conforme à la norme NMB-003 du Canada.
•

Radio Frequency (RF) statement

To comply with FCC's and Industry Canada's RF exposure requirements, the following antenna installation
and device operating configurations must be satisfied.
Remote point-to-multi-point antenna(s) for this unit must be fixed and mounted on outdoor permanent
•
structures with a separation distance between the antenna(s) of greater than 20 cm [7.87 in] and a
separation distance of at least 20 cm [7.87 in] from all persons.
Remote fixed point–to-point antenna(s) for this unit must be fixed and mounted on outdoor permanent
•
structures with a separation distance between the antenna(s) of greater than 20 cm [7.87 in] and a
separation distance of at least 100 cm [39.37 in] from all persons.
Furthermore, when using integral antenna(s) the Multinode unit must not be co-located with any other
•
antenna or transmitter device and have a separation distance of at least 20 cm [7.87 in] from all
persons.
50040849
Issue 3
2. 1BSpecifications
2.3. Agency Compliance Information
Honeywell Sensing and Control 5