Motorola AP 73 User Manual page 4

until LCD displays
number location (1 to 9), or press
code. Enter the phone number (up to 12 digits), or access/deaccess code
(up to 8 digits). Press Toggle Light/Enter and Parameter Transfer But-
ton to accept.
Displaying a Stored Number: To view stored phone number, press
followed by a phone number location (1 to 9). To view access/deaccess
code, press followed by
view the last manually dialled number.
Voice Selective Call (Optional)...
Receiving a Voice Selective Call: When radio decodes a Voice Selective
Call, LCD indicates the type of SelCall message being received:
, (Group Call), or
(Individual Call),
Sending a Voice Selective Call: Press and hold PTT, then dial the required
ID. Release PTT and wait for a response.
Special Programming Mode (SPM)...
Entering SPM: Hold down
after the radio sounds a ringing SPM start-up tone.
Exiting a Menu Item: Select another menu item by rotating Selector
Knob. NOTE: This aborts the phone access / deaccess codes entry, if
Toggle Light/Enter and Parameter Transfer Button is not pressed first.
Exiting Special Programming mode: Turn radio off, then on again.
The following table provides a complete list of the available parameters
and their programming procedures (items with similar procedures are
grouped together).
First go to SPM then rotate Selector Knob to the desired menu item (refer
to the SPM display column below).
SPM Browse Menu
SPM Dis- SPM Browse Menu
play Item
Edit Channel Scan
List
Erase Single Chan-
nel from Memory
(with a flashing cursor). Enter a phone
/ to enter access / deaccess
/
. Press followed by
(All Call).
while turning on the radio. Only release
To Edit
Press or to scroll through
the channels (01 to 20). Press Toggle
Light/Enter and Parameter Change
Button to toggle status of channel.
Press or to scroll through the
channels (01 to 20) and Toggle Light/
Enter and Parameter Transfer Button
to erase a programmed channel.
,
to