Table of Contents
Advertisement
MHz Operation...
Selecting Frequency Step Size: Press
is shown. Rotate Selector Knob to the desired frequency step size then
press any key to accept.
Selecting Receive Frequency: In Mhz mode, enter desired frequency
(whole or part) or/and rotate Selector Knob to the required frequency.
s
Selecting TX Offset: Pres
positive offset ('+' displayed), standard negative offset ('-' displayed) and
user-defined TX frequency ("+ -" displayed).
Programming User-Defined TX Frequency: Pres
shown. Enter desired TX frequency (whole or part) or/and rotate Selec-
tor Knob to the required frequency then press Toggle Light / Enter and
Parameter Transfer Button.
Memory Mode Operation...
Selecting Memory Channel: In Memory mode, rotate Selector Knob.
Programming Memory Channel: In MHz mode, select the desired fre-
quency, type of offset and offset frequency then press Toggle Light /
Enter and Parameter Transfer Button until
Selector Knob to select the desired memory channel then press Toggle
Light / Enter and Parameter Transfer Button to accept.
Loading Memory Channel: In Memory mode, rotate Selector Knob to
the desired memory channel then press Toggle Light / Enter and Param-
eter Transfer Button to accept.
Scan Operation...
Scanning Frequency Range/Memory Channel : In Mhz/Memory mode,
SCAN
press
to begin scanning the preprogrammed frequency range/chan-
D
N-DEL
nel. 'SCAN' indicator flashes when scanning is in progress, and lights up
continuously when it is receiving a signal.
Transmitting During Band Scanning: Press PTT when scan is locked at
a frequency.
Deleting Nuisance Channel: With radio locked onto unwanted channel,
SCAN
press
until you hear two beeps.
D
N-DEL
DTMF Telephone Interconnect...
Placing a Telephone Call: Press and hold PTT and dial access code (or,
if radio has preprogrammed code, press
PTT and wait for dial tone. If successful, press and hold PTT, then dial
phone number (or, if radio has preprogrammed phone number, press
followed by number button that stores phone number). Press PTT to talk,
release to listen. To hang up, press and hold PTT, then dial deaccess code
(or, if radio has preprogrammed code, press
Last Number Redial: Once you have accessed the telephone network,
press and hold PTT, then press
manual entered phone number).
Storing a Phone Number or Access/Deaccess Code: Press and hold
LOW
until current frequency size
C
STEP
to toggle between no offset , standard
s
until '+ -' is
xxx
is shown. Rotate
followed by
). Release
followed by
).
followed by
(only works with
Advertisement
Table of Contents
