Troubleshooting; Led And Audible Alarm Troubleshooting - HP R1500 - UPS XR User Manual

Troubleshooting

LED and audible alarm troubleshooting

This UPS is designed for durable, automatic operation and also alerts you whenever potential operating
problems might occur. Usually the alarms shown on the control panel do not mean that the output power is
affected. Instead, they are preventive alarms intended to alert you of a possible condition.
The following table describes typical alarms and conditions. If an alarm appears with a service code, contact
HP technical support
To check the Event Log for a list of active alarms:
Press any button on the front panel display to activate the menu options.
1.
Press the down arrow button until EVENT LOG displays.
2.
Press the right arrow button to display the list of alarms and conditions.
3.
Alarm On Battery
LED LED
On
On
On
On
("HP contact information" on page 107).
Power On Auto-Bypass
LED LED
On
Flashing
On
Flashing
Audible alarm Condition
UPS is in Normal
mode (on page
65).
A new message is
active.
On—1 beep On Battery
every 5 seconds on battery" on
page 100)
On—Continuous Battery Low
for 10 seconds ("Battery low
condition" on page
96)
On—1 beep Battery Breaker (on
every 3 seconds page 95)
On—1 beep On Bypass
every 3 seconds on bypass" on
page 100)
On—1 beep Bypass
every 1 seconds Unavailable
("Bypass is
unavailable" on
page 96)
On—1 beep Battery Connection
every 3 seconds ("Battery
connection
condition" on page
96)
("UPS is
("UPS is
Troubleshooting 94