Wheels; Removing/Installing Rear Wheels - Invacare A-4 User Manual

Hide thumbs Also See for A-4:

Table of Contents

8 Wheels

WARNING

After any adjustments, repair or service and before use, make sure all attachment hardware is tightened securely -

otherwise, injury or damage may result.

8.1

Push and hold in the tip of the quick-release axle and pull the axle with rear wheel out of the wheelchair frame.

Push in the tip of the quick-release axle again and pull the axle out of the existing rear wheel.

Repeat STEPS 1-2 for the opposite rear wheel.

To reinstall the existing or install the new rear wheel onto the wheelchair, reverse STEPS 1-3.

WARNING

Pull the rear wheel to ensure that the detent pin

and locking pins of the quick/quad-release axle are

fully released before operating the wheelchair.

The locking pins MUST be protruding past the

inside of the rear wheel axle bushing for a positive

lock.

Keep locking pins clean.

If locking pins are not protruding past the inside of axle bushing or

there is too much movement of rear wheel assembly in a back and

forth position, refer to Adjusting Quick- Release Axle on page 64

or Removing The Play From The Rear Wheels on page 66.

Part No 1110545

Wheelchair Frame

Quick Release Axle

FIGURE 1

8 WHEELS

Removing/Installing Rear Wheels

Invacare® A-4® Wheelchair

Table of Contents