Opening/Closing Camber Clamps - Invacare A-4 User Manual

Hide thumbs Also See for A-4:

Table of Contents

7 FRAME

7.5

Opening/Closing Camber Clamps

WARNING

Quick-Release Levers - Make sure the quick-release levers are in the closed position before using the wheelchair, otherwise

personal injury or damage to the wheelchair may occur.

Standard and Suspension Camber Clamps - Make sure the hex screws are securely tightened before using the wheelchair,

otherwise personal injury or damage to the wheelchair may occur.

CAUTION

DO NOT close the quick-release levers or tighten the socket screws or hex screws without camber inserts in the axle

tube. Damage to the axle tube will occur.

Perform one of the following to open a camber clamp:

Quick-Release Levers - Pull the quick-release lever to the open position.

Standard Camber Clamps - Loosen, but do not remove the socket screw on the camber clamp.

Suspension Camber Clamps - Loosen, but do not remove the hex screw on the bottom rear of the camber clamp.

Perform one of the following to close a camber clamp:

Quick-Release Levers - Secure the quick-release lever to the camber clamp by threading it completely into the camber clamp. Push the

quick-release lever on the camber clamps to the closed position.

Standard Camber Clamps - Securely tighten the socket screw to secure the axle tube.

Suspension Camber Clamps - Securely tighten the hex screw on the bottom rear of the camber clamp to secure the axle tube.

Invacare® A-4® Wheelchair

Part No 1110545

Table of Contents