3g storm series including power tilt only elevating seat only power tilt and elevating seat 2g tarsys (2gt- tilt, 2gr- recline, 2gtr- tilt/recline) (132 pages)
Page 1
Owner's Operator And Maintenance Manual Owner's Operator and Maintenance Manual A4 and A4 Titanium (Adjustable Seat Angle) DEALER: THIS MANUAL MUST BE GIVEN TO THE USER OF THE WHEELCHAIR. USER: BEFORE USING THIS WHEELCHAIR, READ THIS MANUAL AND SAVE FOR...
Page 2
WARNING DO NOT OPERATE THIS EQUIPMENT WITHOUT FIRST READING AND UNDERSTANDING THIS MANUAL. IF YOU ARE UNABLE TO UNDERSTAND THE WARNINGS, CAUTIONS AND INSTRUCTIONS, CONTACT A QUALIFIED TECHNICIAN BEFORE ATTEMPTING TO USE THIS EQUIPMENT - OTHERWISE INJURY OR DAMAGE MAY RESULT.
LABEL LOCATIONS WARNING WARNING Refer to Owner's Manual DO NOT OPERATE WITHOUT for proper anti-tipper THE ANTI-TIP TUBES INSTALLED. REV. 5/98 P/N 60106X144 setting. 1085379 Detent balls should extend beyond the diameter WARNING of the axle bushing for a positive lock. Keep detent balls clean.
SPECIFICATIONS INVACARE A4 * NOTE: The seat-to-floor heights are based on pneumatic tires and pneumatic tires with flat free inserts. If wheelchair is equipped with urethane tires, subtract 1/4-inch from the measurements listed above. All heights are measured with properly inflated new tires. These heights can vary +1/4-inch due to tire wear. Add one (1) inch for wheelchairs with the suspension option.
Section 1 - General Guidelines includes the following: Stability Operating Information Weight Training Weight Limitation Safety/Handling of Wheelchairs STABILITY STABILITY WARNINGS ü ü N/A N/A N/A N/A N/A N/A ü ü ü ü N/A N/A N/A N/A N/A ü...
Page 15
STAIRWAYS WARNING ESCALATORS? SORRY! Part No. 1110545 A4...
Page 16
TRANSFERRING TO AND FROM OTHER SEATS WARNING CAUTION NOTE: This activity may be performed independently provided you have adequate mobility and upper body strength. A4 Part No. 1110545...
Section 2 - Safety Inspection includes the following: Safety Inspection Checklist Troubleshooting Maintenance NOTE: Every six (6) months or as necessary, take your wheelchair to a qualified technician for a thorough inspection and servicing. Regular cleaning will reveal loose or worn parts and enhance the smooth operation of your wheelchair.
Section 3 - Upholstery includes the following: Unfolding/Folding the Back Removing/Installing Standard Back Upholstery Adjustable Tension Back Upholstery Seat Upholstery Replacement WARNING UNFOLDING/FOLDING THE BACK (FIGURE 1) WARNING Back Cane Back Release Cord (Not Shown) NOTE: Back upholstery removed for clarity. A4...
REMOVING/INSTALLING STANDARD BACK UPHOLSTERY (FIGURE 2) WARNING REMOVING STANDARD BACK UPHOLSTERY INSTALLING STANDARD BACK UPHOLSTERY Back Upholstery Fold Fastening Strips Fastening Flap Fastening Flap Loops Back Canes Part No. 1110545 A4...
ADJUSTABLE TENSION BACK UPHOLSTERY (FIGURE 3) WARNING THE ADJUSTABLE TENSION STRAPS Fastening Strap Back Upholstery Seat Portion of Back Cover Upholstery Cover Fastening Strap THE BACK UPHOLSTERY COVER Back Cane Mounting Hole Back Upholstery Anchor Loops Mounting Screw Back Upholstery Adjuster Straps REMOVING/INSTALLING ADJUSTABLE TENSION BACK UPHOLSTERY NOTE: To remove adjustable tension back upholstery, reverse STEPS 2-4.
NOTE: Clean the upholstery with warm water and mild detergent to remove superficial soil. WARNING SEAT UPHOLSTERY REPLACEMENT (FIGURE 4) Phillips Screws Seat Upholstery Seat Frame NOTE: Wheelchair frame not shown for clarity. Part No. 1110545 A4...
Section 4 - Frame includes the following: Back Angle Adjustment Back Height Adjustment Rear Seat-to-Floor Height Adjustment Replacing Seat Frame Opening/Closing Camber Clamps Determining Toe in/Toe out Adjusting Toe in/Toe out Adjusting the Axle Tube Repositioning Camber Inserts (Adjusting Rear Wheel Camber) Adjusting Wheelbase Length (Adjusting Center of Gravity) Adjusting Wheelbase Width Replacing Axle Tube...
ADJUSTING TOE IN/TOE OUT AXLE TUBE POSITIONING FOR 0°/3°, 0°/6°, 3°/6° OR 9°/12° CAMBER INSERTS (FIGURE 7) CAUTION AXLE TUBE POSITIONING FOR 0°/9°, 0°/12°, 3°/9°, 6°/9° , 3°/12° OR 6°/12° CAMBER INSERTS (FIGURE 7) WARNING CAUTION 0°, 3° or 6° Camber. 9°...
Page 34
AXLE TUBE POSITIONING FOR 0°/3°, 0°/6°, 3°/6° OR 9°/12° CAMBER INSERTS - NO ADJUSTMENT REQUIRED - Axle Tube - LOCKED OUT by Toe Adjustment Rings and Will NOT Rotate AXLE TUBE POSITIONING FOR 0°/9°, 0°/12°, 3°/9°, 3°/12°, 6°/9° or 6°/12° CAMBER INSERTS Axle Tube - Will Rotate DOWN Only...
Section 5 - Wheels includes the following: Removing/Installing Rear Wheels Adjusting Quick-Release Axle Installing Quad-Release Axle Adjusting the Quad-Release Handle In and/or Out Removing the Play From the Rear Wheels Handrim Replacement Repairing/Replacing Rear Wheel Tire/Tube Wheel Lock Adjustment/Replacement Replacing/Adjusting Casters Replacing Forks Adjusting Caster Height Adjusting Front Seat-To-Floor Height...
Section 8 - Arms includes the following: Installing the T-Arm Sockets Installing/Removing the T-Arms Adjusting the T-Arms Adjusting the T-Arm Transfer Assists and/or Side Guards Replacing the T-Arm Locking Lever Installing the Half Arm Socket Adjusting Half Arm Height WARNING INSTALLING THE T-ARM SOCKETS (FIGURE 1) Part No.
ADJUSTING T-ARM TRANSFER ASSISTS AND/OR SIDE GUARDS (FIGURE 7) Small Side Guards - Move the bottom clamp up one (1) of two (2) mounting positions in the side guard. Large Side Guards - Move the bottom clamp up one (1) of three (3) mounting positions in the side guard.
Section 9 - Suspension - includes the following: Elastomers and Suspension Replacing Rear Elastomers Replacing Front Elastomers WARNING ELASTOMERS AND SUSPENSION REPLACING REAR ELASTOMERS (FIGURE 1) Part No. 1110545 A4...