Anti-Tipper Replacement - Invacare A-4 User Manual

10 ANTI-TIPPER
2. Adjust the height of the anti-tipper wheels to between 1
3. Repeat STEPS 1-2 for the opposite anti-tipper.

10.3 Anti-tipper Replacement

WARNING
When anti-tippers are used, anti-tippers MUST be adjusted to maintain a 1-1/2 to 2 inch clearance between the bottom of
the anti-tipper wheels and the ground/ floor. This spacing should ALWAYS be checked whenever adjustments/changes are
made to the wheelchair. Failure to maintain proper spacing may result in the chair tipping over backward causing serious
injury or property damage.
1. Press in the release button that secures the existing anti-tipper to the anti-tipper socket and remove the anti-tipper from the anti-tipper socket.
2. Insert the new anti-tipper into the anti-tipper socket until release button engages.
3. Press in the release button on the anti-tipper bar and install the anti-tipper wheels onto the new anti-tipper bar.
4. Repeat STEPS 1-3 for the opposite anti-tipper.
5. Measure the distance between the bottom of the anti-tipper wheels and the ground floor.
6. If necessary, adjust the height of the anti-tippers. Refer to Anti-tipper Adjustment on page 87.
Invacare® A-4® Wheelchair
1
/ and 2 inches of the ground/floor.
2
PART NUMBER
1112178
MEASUREMENT
1
21 / inches
8
88
Part No 1110545