Axle Tube Positioning For 0°/3°, 0°/6°, 3°/6° Or 9°/12° Camber Inserts; Axle Tube Positioning For 0°/9°, 0°/12°, 3°/9°, 6°/9°, 3°/12° Or 6°/12° Camber Inserts - Invacare A-4 User Manual

7.8 Axle Tube Positioning For 0°/3°, 0°/6°, 3°/6° or 9°/12° Camber Inserts
CAUTION
DO NOT rotate the axle tube if the axle tube is locked out by the toe adjustment rings. If a locked out axle tube is rotated,
damage to the toe adjustment rings will occur.
Refer to FIGURE 7 for a description of a locked out axle tube.

There is NO adjustment required to maintain a correct toe in/toe out measurement.
The axle tube will be locked out by the toe adjustment rings and will NOT rotate.
7.9 Axle Tube Positioning for 0°/9°, 0°/12°, 3°/9°, 6°/9°, 3°/12° or 6°/12° Camber Inserts

Stand behind the wheelchair to determine left or right.
WARNING
Quick-Release Levers - Make sure the quick-release levers are in the closed position before using the wheelchair, otherwise
personal injury or damage to the wheelchair may occur.
Standard and Suspension Camber Clamps - Make sure the hex screws are securely tightened BEFORE using the wheelchair,
otherwise personal injury or damage to the wheelchair may occur.
CAUTION
DO NOT close the quick-release levers or tighten the socket screws or hex screws without camber inserts in the axle
tube. Damage to the axle tube will occur.
0°, 3° or 6° Camber
1. Open the camber clamps. Refer to Opening/Closing Camber Clamps on page 46.
2. Slowly rotate the axle tube until the tab on the left toe adjustment ring is stopped against the LOWER edge of the camber clamp.
3. Close the camber clamps. Refer to Opening/Closing Camber Clamps on page 46.
Part No 1110545
49
7 FRAME
Invacare® A-4® Wheelchair