Replacing Axle Tube - Invacare Top End Everyday Series User Manual

Adjustable Camber System
1. Open the camber clamp.
WARNING
NEVER position the camber inserts in the axle tube with more than 3 inches (7.62 cm) (12 indexing marks showing) of the camber insert
outside of the axle tube. The camber inserts will not be securely tightened in the axle tube. Possible injury to the user or damage to the
wheelchair may occur.
2. Position camber insert to the desired position. Make sure there are
no more than 3 inches (7.62 cm) (12 indexing marks showing) of the
camber inserts outside of the axle tube.
3. Slide the indexing ring on the camber insert until it is flush with the
camber clamp.
 Before using the wheelchair, make sure both camber
inserts are set at the same indexing mark. This will make
sure the distance between the rear wheel and the
wheelchair is the same on both sides.
4. Close the camber clamp.
5. Repeat STEPS 1-4 for opposite side of the wheelchair.

6.14 Replacing Axle Tube

 The camber bar is always mounted to the bottom of the wheelchair frame.
There is no need to remove the two camber clamps when replacing the axle tube.
1. Adjustable Camber System Only - Note the position of the camber inserts so they can be installed at the same position in the new axle tube.
2. Open the camber clamps.
3. Remove the two rear wheels.
4. Adjustable Camber System Only - Remove the camber inserts positioned in the axle tube.
Part No 1171801
Indexing Marks
Camber Insert
59
Indexing
Ring
Camber Clamp
Invacare® Top End® Everyday Series
6 WHEELS
Axle
Tube