Iopn.scsiprovider Commands; Iopn.scsiprovider Set Mirror Copy Bias - HP NetServer AA 6200 Administrator's Manual

IOPn.ScsiProvider Commands

The IOPn.ScsiProvider commands display information about the SCSI Provider.
lists the IOPn.ScsiProvider commands.
Command

IOPn.ScsiProvider Set Mirror Copy Bias

IOPn.ScsiProvider Show Bad Block Status
IOPn.ScsiProvider Show Mirror Copy Bias
IOPn.ScsiProvider Show Mirror Status
IOPn.ScsiProvider Set Mirror Copy Bias
This command sets a bias (preference) favoring either CE disk throughput or mirror copy
completion time. This setting is only relevant when a mirror copy is in progress. By default, the
bias is two.
Command IOPn.ScsiProvider Set Mirror Copy Bias
Console Syntax MTCCONS IOPn.ScsiProvider Set Mirror Copy Bias
n – the ID number of the IOP (1 or 2)
Variables
x – a value between 0 and 4, where 0 sets a preference for CE disk throughput,
The setting of the bias value has an immediate effect. For example, if a mirror
Results
copy is in progress and you change this setting from 2 to 4, the mirror copy
has an increased preference over CE disk throughput. The setting remains in
effect, even after IOPs are rebooted.
See Also
IOPn.ScsiProvider Show Mirror Copy Bias
5-74
Table 5-32 IOPn.ScsiProvider Commands
and 4 sets a preference for mirror copy completion time. By default, the
bias is 2.
Page
5-74
5-75
5-76
5-77
HP Netserver AA Solution Administrator's Guide
Table 5-32