Iopn.diskx Enable Mirrored Disk - HP NetServer AA 6200 Administrator's Manual

IOPn.Diskx Enable Mirrored Disk

Warning: Using this command may cause a mirror set copy. Read all
This command attempts to enable a mirrored SCSI disk, indicated by
faulted. The disk is enabled without having to reboot the IOP under most circumstances.
A disk is faulted when it cannot respond to a read or write request. The disk's failure to respond
to a read or write request may be transient or permanent.
This command is used to enable a disk following a repair or replacement. For instructions about
how to replace a disk, refer to
A disk experienced read or write errors and was deemed to be faulted, then the faulted state
would remain across IOP reboots, even if you replaced the faulted disk. In this case, you must
explicitly enable the disk to clear its faulted condition.
Command IOPn.Diskx Enable Mirrored Disk
Console Syntax MTCCONS IOPn.Diskx Enable Mirrored Disk
n – the ID number of the IOP (1 or 2)
Variables
x – the ID number of the SCSI disk
The disk remirroring process is initiated, if necessary. If a disk is enabled
Results
and it becomes a mirror copy target, but the copy has not started yet, the disk
remains offline until the copy begins; it does not transition to online until the
mirror copy begins.
If this command does not succeed, examine the event log for details.
See Also
IOPn.Diskx Reset Mirror Copy
IOPn.ScsiProvider Show Mirror Status
Commands
instructions in this section before using this command.
Replacing a Failed Mirrored Disk
, that is disabled or
Diskx
on page 9-27.
5-31